5.5v DC Micro Blower, Crimped

Say hello to our little friend, the 5.5 volt Micro Blower! This micro blower component utilizes power-saving axial air-gap cooling and is ideal for cooling the heat sink on your 3D printer, especially if you are building your own hot end or an entire RepRap 3D printer.

Read more
LulzBot Mini v1.0, Boxed for Retail, NA
TAZ 3D Printer, v5.0, Boxed for Retail, NA

The Micro Blower can also be used for Arduino, LED lighting, BeagleBone Black, robotics, and other applications! The Micro Blower is a great choice because it requires low start up voltage and offers up to 40 percent power savings over traditional fans, meaning your project can do more with the same amount of power. Plus, its compact 250 mm long design and low-profile allow your work to stand out.

Parts Included

1 Micro Blower with unterminated wires


30 AWG

Voltage: 5.5V

2 wire with bare ends (not shown in photo)

Speed: 9000 RPM

Airflow: 0.57 CFM

More Information

Pelonis part number: RFB2008

LulzBot BOM: EL-FA0020




$ 18 00

5.5v DC Micro Blower, Crimped

$ 18 00

A notice about cookies

This website uses cookies. By continuing to browse this site, you agree to their use.

See all options