Loading...

LulzBot TAZ Etched Modular Print Bed Heater

The LulzBot TAZ Modular 3D Printer Bed System ensures your LulzBot TAZ is going strong for years to come with improved ease-of-maintenance, increased versatility, and better heat uniformity across the bed surface. The 3D printer heated bed system is an easy and smart upgrade to a LulzBot TAZ 3D Printer (compatible with 24-volt versions only, TAZ 3-6, Workhorse, and Pro).

The LulzBot TAZ Modular 3D Printer Bed is the lower half of the TAZ Modular Print Bed System and features a silicone heat pad vulcanized to a stainless-steel heat spreader.


Works with: LulzBot TAZ WorkhorseLulzBot TAZ ProLulzBot TAZ 6LulzBot TAZ 5LulzBot TAZ 4LulzBot TAZ 3

Read more
Compatibility:
LulzBot TAZ 3D Printer, Pro Boxed for Retail, NA
LulzBot TAZ 3D Printer, Workhorse, Boxed for Retail, NA
LulzBot TAZ 3D Printer, v6.0 Boxed for Retail, NA
TAZ 3D Printer, v3.0
TAZ 3D Printer, v4.1, Boxed for Retail
TAZ 3D Printer, v5.0, Boxed for Retail, NA

Etched stainless steel heat spreader for maximizing uniform heat distribution across the print surface.

Compatible with all 24-volt LulzBot TAZ 3D Printers (TAZ 3 through TAZ 6).

Parts Included

(1) LulzBot TAZ Etched Modular Print Bed Heater

(1) Wire tie

Additional Parts Required

TAZ 6 Users

TAZ 6 Bed Corners for Modular Print Bed System (not included - print yourself) 

LulzBot TAZ 6 Users should 3D print four TAZ6_Modular_Bed_Corner.stl  in NinjaFlex, with an infill density of 60% using the High Speed setting in Cura LulzBot Edition



TAZ 3 - 5 Users

(1) TAZ 5 Bed Corners for Modular Print Bed System (not included - print yourself)

LulzBot TAZ 5 Users should 3D print one t5_flexy_standoff_8mm.stl in NinjaFlex, with an infill density of 60% using the High Speed setting in Cura LulzBot Edition. After printing, place the standoff on the center of the aluminum bed plate prior to installing the modular heat bed heater and glass.



Reach out to the support team if you are unable to print with flexible filament: LulzBot.com/Support.

More Information

Set-Up Instructions

Source

Bill of Materials

LulzBot TAZ 5 Users should 3D print one t5_flexy_standoff_8mm.stl in NinjaFlex, with an infill density of 60% using the High Speed setting in Cura LulzBot Edition. After printing, place the standoff on the center of the aluminum bed plate prior to installing the modular heat bed heater and glass. Reach out to the support team if you are unable to print with flexible filament: LulzBot.com/Support.

$ 140 00
140.0
Overview


LulzBot TAZ Etched Modular Print Bed Heater


$ 140 00
140.0

.
A notice about cookies

This website uses cookies. By continuing to browse this site, you agree to their use.

See all options